Table of Contents
Advertisement
8K - 10
WINDSHIELD WIPER AND WASHER SYSTEMS
•
ELECTRICAL
LEADS
HORN PAD
STEERING
COLUMN
MOUNTING
SCREWS (2)'
Fig. 8 Standard Steering Wheel
ELECTRICAL
LEADS
J 908G-5
HORN PAD
MOUNTING-
SCREWS (3)
Fig. 9 Optional Steering Wheel
J908G-6
TOOL
C-3428B
J908M-7
Fig. 10 Removing Steering Wheel (Typical)
WIRE
TROUGH
RH1333
Fig. 11 Wire Trough Cover
HORN AND TURN
"SIGNAL CONNECTOR
WEDGE BLOCK
WINDSHIELD WIPER
CONNECTOR
FROM KEY-IN LAMP
FROM
KEY-IN
SWITCH
J908K-37
Fig. 12 Disconnecting Wires
(6) Remove steering wheel n u t and remove steering
wheel w i t h p u l l e r C-3428B (Fig. 10).
(7) Pry out w i r i n g t r o u g h retainers and l i f t off w i r -
i n g t r o u g h . N e w retainers m a y be required for reas-
sembly (Fig. 11).
(8) Disconnect wash/wipe s w i t c h connector and, i f
equipped, i n t e r m i t t e n t w i p e module connector a n d
speed control connector (Figs. 12 and 13).
(9) Remove two screws t h a t attach the lock housing
to t h e lock housing a n d remove the lock housing
cover.
(10) Remove t h e wipe/wash switch assembly ( F i g .
14)
(11) P u l l t h e hider up t h e control stalk and remove
the two screws t h a t a t t a c h the control s t a l k sleeve to
the wipe/wash switch (Figs. 14 and 15).
(12) Remove wash/wipe s w i t c h control knob from
end of m u l t i f u n c t i o n control s t a l k (Fig. 15).
(13) Rotate the control s t a l k shaft to the f u l l clock-
wise position and remove t h e shaft from the switch
by p u l l i n g s t r a i g h t out o f the switch (Fig. 16).
For i n s t a l l a t i o n , reverse t h e removal
procedures.
T i g h t e n steering wheel n u t t o 61 N-m (45 f t . lbs.).
WIPER SWITCH REPLACEMENT-TILT COLUMN
(1) Disconnect battery negative cable.
(2) Remove steering c o l u m n cover (Fig. 17).
Advertisement
Table of Contents
