Glove Box Lock; Catch; Illumination Bulb Replacement; Glove Box And Bin - Dodge D150 1990 Service Manual

•
INSTRUMENT PANEL AND GAUGES 8E - 21
(2) T h e b i n is removed b y unsnapping b i n from (4) Push lock cylinder into latch assembly, a n d re-
door assembly. move key.
Fig. 6 Glove Box and Bin
Installation
(1) Snap b i n onto door.
(2) M o u n t assembly to lower reinforcement w i t h
four m o u n t i n g screws.
GLOVE BOX LOCK
Removal
(1) Open glove box door.
(2) T u r n lock i n t o locked position and remove key.
(3) Insert a s t i f f w i r e i n rear slot o f lock mecha-
n i s m and depress r e t a i n i n g t u m b l e r into cylinder.
(4) W h i l e h o l d i n g t u m b l e r down w i t h w i r e i n lock
cylinder, i n s e r t key.
(5) Remove w i r e a n d p u l l out lock cylinder.
(6) Remove l a t c h m o u n t i n g screws and remove as-
sembly.
Installation
(1) Position l a t c h assembly i n t o place on glove box
door, i n s t a l l m o u n t i n g screws and t i g h t e n securely.
(2) Depress r e t a i n i n g t u m b l e r into lock cylinder
and insert key.
(3) Position assembly so t h a t i t w i l l be i n the closed
position w h e n installed.
CATCH
Removal
(1) Open glove box door.
(2) Remove catch m o u n t i n g screws.
(3) Remove catch.
Installation
(1) Position catch and spring n u t into place, i n s t a l l
m o u n t i n g screws and t i g h t e n securely.
(2) Close glove box door.
ILLUMINATION BULB REPLACEMENT
SNOW PLOW CONTROLS ILLUMINATION
LAMP
Removal
(1) Remove t w o screws on r i g h t side of snow plow
control housing.
(2) Loosen t w o screws on left side of housing a n d
slide housing to the r i g h t and p u l l away from i n s t r u -
m e n t panel.
(3) Remove four screws holding bezel to housing.