Table of Contents
Advertisement
•
WINDSHIELD WIPER AND WASHER SYSTEMS
8K - 13
wipe and speed control connectors (Figs. 23 and 24).
HORN AND TURN
WEDGE BLOCK
WINDSHIELD WIPER
c S p E f £ ^
FROM
CONNECTOR
LjEfe®)
KEY-IN
SWITCH
FROM KEY-IN LAMP
J908K-37
Fig. 24 Disconnecting Wires
(12) Remove 3 t u r n signal switch attaching screws.
Place shift lever i n l o w (1) position. W r a p a piece o f
tape around the connector and wires to prevent snag-
g i n g w h e n removing t h e switch (Fig. 25). Remove
t u r n signal switch and w i r i n g .
Fig. 25 Tape Connector and Wires
(13) Remove i g n i t i o n k e y l a m p (Fig. 26).
(14) The lock cylinder m a y be removed i n any po-
sition from ACCESSORY to O N . The lock position is
recommended because o f its positive location.
Insert a t h i n tool (small screwdriver or s h i m stock)
i n t o t h e slot next to t h e switch m o u n t i n g screw boss
( r i g h t h a n d slot) a n d depress spring l a t c h a t bottom
of slot, w h i c h releases lock. Remove lock (Fig. 27).
The buzzer switch can be pulled s t r a i g h t out o f the
housing (Fig. 28). A straightened paper clip or s i m i -
l a r piece o f stiff w i r e w i t h a hook bent on one end
should be inserted i n t h e exposed loop of the wedge
spring, t h e n a s t r a i g h t p u l l on t h e w i r e w i l l remove
b o t h spring and switch ( i f the lock cylinder is not re-
moved before t h e switch, i t m u s t be i n t h e O N posi-
tion).
CAUTION: If wedge spring is dropped on removal, it
could fall into the column, requiring complete dis-
assembly to retrieve spring.
Fig. 26 Ignition Key Lamp and Hazard Warning
Knob.
Fig. 27 Removing Lock Cylinder
Fig. 28 Key Buzzer Switch and Wedge Spring
(15) Remove 3 housing cover screws and remove
Advertisement
Table of Contents
