Fuseblock And Flashers; Overdrive Lockout Switch; Message Center Module; Hood Release - Dodge D150 1990 Service Manual

•
INSTRUMENT PANEL AND GAUGES 8E - 19
(3) Depress stops and close glove box door.
OVERDRIVE LOCKOUT SWITCH (FIG. 4J
Removal
(1) Remove map lamp.
(2) Remove cluster bezel (refer to Cluster Bezel Re-
moval).
(3) Reach behind bezel a n d disconnect lockout
s w i t c h connector.
(4) Depress r e t a i n i n g tabs o n t o p a n d bottom o f
s w i t c h and p u l l switch out o f module.
Fig. 4 Overdrive Lockout Switch and Message
Center Module
Installation
(1) Position lockout switch i n t o module a n d p u s h
u n t i l r e t a i n i n g tabs lock into place.
(2) Connect s w i t c h connector.
(3) I n s t a l l i n s t r u m e n t cluster bezel t o panel.
MESSAGE CENTER MODULE (Fig. 4)
REMOVAL
(1) Remove map lamp.
(2) Remove cluster bezel (refer t o Cluster Bezel Re-
moval).
(3) Reach b e h i n d bezel a n d disconnect lockout
s w i t c h and message center connectors.
(4) Remove three module r e t a i n i n g screws and one
clip and p u l l module from bezel.
(5) Remove overdrive lockout switch from module.
INSTALLATION
(1) I n s t a l l overdrive lockout switch i n t o module.
(2) Position module on bezel and i n s t a l l screws and
clip.
(3) Connect lockout switch a n d message center con-
nectors.
(4) I n s t a l l i n s t r u m e n t cluster bezel t o panel.
(5) I n s t a l l map lamp.
FUSEBLOCK AND FLASHERS
FUSEBLOCK
The fuseblock is located d i r e c t l y below the steering
column, on t h e lower steering column cover.
Removal
(1) Push fuseblock l o c k i n g t a b o n column cover
d o w n w a r d and lower fuseblock. T h e following compo-
nents p l u g into t h e fuseblock.
(1) Fuses.
(2) 30 amp circuit breakers.
(3) T u r n signal flasher.
(4) H o r n relay.
(5) Hazard W a r n i n g Flasher.
Installation
(1) Position fuseblock t o steering column cover.
(2) Push locking tab t o lock fuseblock i n position.
HOOD RELEASE
REMOVAL
(1) Disengage cable from hood l a t c h i n engine com-
p a r t m e n t .
(2) Remove four screws holding handle assembly to
i n s t r u m e n t panel.
(3) Remove assembly b y p u l l i n g cable r e a r w a r d
t h r o u g h dash panel grommet.
INSTALLATION
(1) Feed cable assembly forward t h r o u g h dash
panel grommet.
(2) M o u n t handle assembly to i n s t r u m e n t panel
w i t h four screws.
(3) Connect cable to hood latch.
FOUR WHEEL DRIVE INDICATOR
REMOVAL
(1) Remove map lamp.
(2) Remove cluster bezel (refer to Cluster Bezel Re-
moval).
(3) Remove t w o screws and remove indicator from
bezel.
INSTALLATION
(1) Position indicator to bezel and attach w i t h t w o
screws.
(2) I n s t a l l cluster bezel.