Table of Contents
Advertisement
8J - 6
TURN SIGNALS AND HAZARD WARNING FLASHER
Fig. 11 Removing Lock Plate Retaining Ring Using
ToolC-4156
(3) O n column shift, place gear shift lever i n t o
P A R K position.
(4) Assemble upper p a r t o f steering column.
(a)
Standard
Column: Position
t u r n
signal
s w i t c h into place on upper bearing housing. I n s t a l l
three m o u n t i n g screws and t i g h t e n securely. Posi-
t i o n t u r n signal lever (control stalk) t o t u r n signal
switch pivot, t h e n p u t screw t h r o u g h p i v o t a n d
t i g h t e n securely. B e sure t h a t d i m m e r s w i t c h rod is
i n control s t a l k pocket.
(b) T i l t C o l u m n : Position t u r n signal switch i n
upper c o l u m n housing. Place switch i n r i g h t t u r n
position.
I n s t a l l
three
m o u n t i n g
screws a n d
t i g h t e n . P u l l l i n k i n position between t u r n signal
switch a n d wiper-washer switch pivot, and secure
w i t h screw. U s i n g Tool C-4156 i n s t a l l upper bear-
i n g spring, canceling cam, and lock plate, w i t h new
r e t a i n i n g r i n g . I n s t a l l hazard w a r n i n g knob w i t h
screw.
(5) Connect w i r i n g harness connector. I n s t a l l w i r -
i n g t r o u g h t o c o l u m n w i t h 4 plastic buttons.
(6) I n s t a l l lower bezel t o i n s t r u m e n t panel.
(7) I n s t a l l steering wheel, being sure t h a t i t is
properly indexed t o c o l u m n shaft. Torque wheel n u t
to 6 1 N*m (45 ft. lbs.).
(8) Connect h o r n s w i t c h leads a n d i n s t a l l h o r n
switch pad.
(9) Connect b a t t e r y negative cable.
(10) Test operation o f t u r n signals, hazard w a r n i n g
flashers, and h o r n .
Advertisement
Table of Contents
