Table of Contents
Advertisement
8E - 22
INSTRUMENT PANEL AND GAUGES
•
(4)
P u l l
r e a r w a r d a n d remove
l a m p b u l b a n d
socket.
Installation
(IX I n s t a l l l a m p bulb and socket.
(2)
Position bezel
t o housing a n d i n s t a l l four
screws.
(3) Position housing onto t w o left side screws, i n -
s t a l l t w o r i g h t side screws and secure housing t o i n -
s t r u m e n t panel.
ASH TRAY ILLUMINATION
LAMP
Removal
(1) Open ash receiver and remove b i n .
(2) Disconnect wires from cigar lighter.
(3) Remove six screws t h a t r e t a i n assembly to
panel.
(4) W h i l e dropping ash receiver, remove l a m p as-
sembly f r o m t o p of the housing.
Installation
(1) I n s t a l l l a m p assembly into top o f housing.
(2)
Position housing a n d i n s t a l l
s i x m o u n t i n g
screws.
(3) Connect wires t o cigar l i g h t e r .
(4) I n s t a l l b i n and close ash receiver.
MAP LAMP
BULB
To replace b u l b , snap lens out, replace bulb.
FOUR WHEEL DRIVE
INDICATOR
Removal
(1) Remove map l a m p .
(2) Remove cluster bezel (refer t o Cluster Bezel Re-
moval).
(3) Remove b u l b and socket.
Installation
(1) Snap i n b u l b a n d socket.
(2) Replace cluster bezel.
(3) I n s t a l l m a p l a m p .
HEATER
OR HEATER
A/C
ILLUMINATION
LAMP
Removal
(1) Remove map lamp.
(2) Remove cluster bezel (refer t o Cluster Bezel Re-
moval;.
(3) Remove t w o control a t t a c h i n g screws.
(4) P u l l control r e a r w a r d .
(5) Snap out i l l u m i n a t i o n l a m p .
Installation
(1) I n s t a l l b u l b i n t o socket.
(2) Snap socket i n t o control.
(3) Push control forward and i n s t a l l t w o a t t a c h i n g
screws.
(4) I n s t a l l cluster bezel.
(5) I n s t a l l map l a m p .
Advertisement
Table of Contents
