Table of Contents
Advertisement
8E - 18
INSTRUMENT PANEL AND GAUGES
•
Fig. 3 Snow Plow
(4) P u l l rearward, disconnect w i r e f r o m toggle
switch.
(5) Remove toggle s w i t c h b y unscrewing n u t f r o m
front of bezel.
Installation
(1) Position toggle s w i t c h to bezel and i n s t a l l n u t .
(2) Connect wires t o toggle s w i t c h .
(3)
Position bezel t o housing a n d i n s t a l l
four
m o u n t i n g screws.
(4) Check operation o f switch.
(5) Position housing onto t w o left side screws, i n -
s t a l l two r i g h t side screws and secure h o u s i n g t o i n -
strument panel.
CARGO LAMP
SWITCH
Removal
(1) Locate chime module. Grasp chime module a n d
t w i s t i t to remove i t f r o m the bracket.
(2)
Remove w i r i n g
connector
from cargo
l a m p
switch.
(3) Depress lock tabs on switch and push i t out o f
the i n s t r u m e n t panel.
Installation
(1) Hold w i r i n g connector i n s w i t c h opening.
(2) Push switch on t o w i r i n g connector.
Control Assembly
(3) Continue t o push u n t i l switch snaps i n t o place.
(4) I n s t a l l chime module on t o bracket.
MAP LAMP
SWITCH
Removal
(1) Remove 2 a t t a c h i n g screws.
(2) Drop assembly down and remove w i r i n g connec-
tor, t h e n remove map l a m p assembly.
Installation
(1) Connect w i r i n g connector t o l a m p assembly.
(2) Position m a p l a m p assembly t o panel a n d i n -
stall 2 m o u n t i n g screws.
GLOVE BOX LAMP
SWITCH
Removal
(1) Open glovebox u n t i l stops i n b i n rest against i n -
strument panel, depress stops t o clear i n s t r u m e n t
panel
a n d continue p i v o t i n g glovebox
assembly
downward.
(2) Disconnect w i r e to switch.
(3) Snap switch out of panel.
Installation
(1) Snap switch i n t o panel.
(2) Connect w i r e to switch.
Advertisement
Table of Contents
