Dodge D150 1990 Service Manual page 696

NUT
(2)
ASSEMBLY
(200 INCH-POUNDS)
"U" NUT (4)
TIGHTEN NUT TO
. END OF THREAD
FUEL TANK FUEL TANK ON STUD
M
^ U ! ^
G
ASSEMBLY VIEW A* _
STRAPS STRAP ADJUSTAAENT J9014-184
Fig. 7 Ramcharger Fuel Tank Removal/Installation
FUEL TUBES
FUEL TANK
TO FILLER
NECK
VENT
HOSE
J9014-I85
Fig. 8 Fuel Tube Connections—Ramcharger
gauge sending u n i t electrical connector from fuel
p u m p module. Remove ground strap.
(9) Remove fuel filler tube hose a n d fill v e n t hose
from t a n k (Fig. 8 a n d F i g . 9).
(10) Lower fuel t a n k .
INSTALLATION
(1) Position t a n k on transmission jack.
(2) Raise t a n k h i g h enough t o connect t h e fuel
tubes and gauge sending u n i t electrical connector to
t h e fuel pump module a t t h e top o f the t a n k .
(3) Raise t a n k i n t o position.
(4) I n s t a l l t a n k m o u n t i n g straps. Connect " J " bolts
a n d t i g h t e n the nuts as shown i n F i g . 8.
FUEL
TANK FILLER
TUBE
HOSE
CLAMP
FUEL TANK
FILLER
CLAMP
CLAMP
J9014-186
Fig. 9 Fuel Filler Tube and Vent Tube to Filler Neck
Connections
(5) Remove jack.
(6) Connect filler tube and a l l vent hoses. I n s t a l l
new hose clamps a n d t i g h t e n securely.
(7) Connect fuel l i n e i f disconnected to d r a i n t a n k .
Recap d r a i n tube.
(8) Refill fuel t a n k a n d inspect a l l hoses and lines
for leaks.
(9) Reconnect battery ground cable.
FUEL RESERVOIR
The fuel reservoir (Fig. 10) is attached to t h e lower
end of the fuel p u m p module. The purpose of the res-
PRESSURE RELIEF/
ROLLOVER VALVE
ELECTRICAL
TERMINAL
FUEL
RESERVOIR
FUEL GAUGE
SENDING UNIT
RR14G218
Fig. 10 Fuel Pump Module