Dodge D150 1990 Service Manual page 969

21-118 AUTOMATIC TRANSMISSION
8921-231
Fig. 7 Removing/Installing Overdrive Clutch Wave
Ring
Fig. 8 Removing/Installing Overdrive Clutch Flat
Snap
Ring
(5) Remove access cover (Fig. 9). Cover provides ac-
cess t o snap r i n g t h a t holds o u t p u t shaft front bear-
i n g i n place.
•
Fig. 9 Removing/Installing Access Cover
(6) Insert a l i g n m e n t Tool C-6277-2 i n t o sun gear
(Fig. 10). Be sure tool is firmly seated as i t w i l l be
used t o remove e n t i r e gear t r a i n as a n assembly.
(7) A f t e r seating the a l i g n m e n t tool C-6227-2, t u r n
overdrive u n i t over a n d position i t on the a l i g n m e n t
tool (Fig. 11).
(8) E x p a n d t h e o u t p u t shaft bearing snap r i n g w i t h
expandable snap r i n g pliers (Fig. 11). Then l i f t t h e
overdrive case off the g e a r t r a i n .
Fig. 10 Installing Alignment Tool C-6227-2
(9) Remove the governor r e t a i n i n g snap r i n g a n d
remove t h e governor and shaft key (Fig. 12). T h i s
prevents damaging t h e governor when t h e direct
clutch s p r i n g is compressed i n an arbor press.
(10) Set gear t r a i n aside for overhaul operations
and continue disassembly of case components.
(11) Remove t h e output shaft front bearing snap
r i n g (Fig. 13). T h e n remove t h e governor support
snap r i n g .
(12) Remove the governor support and the slip fit
pressure tubes f r o m the case (Fig. 14).
(13) Remove o u t p u t shaft rear bearing snap r i n g
w i t h locking-type snap r i n g pliers (Fig. 15).