Table of Contents
Advertisement
INSTRUMENT PANEL AND GAUGES
8E - 9
CLUSTER MASK AND LENS
REMOVAL
(1) Disconnect battery negative cable.
(2) Remove bezel.
(3) Remove 8 screws.
(4) Remove mask and lens.
INSTALLATION
(1) Position mask and lens.
(2) I n s t a l l 8 screws.
(3) I n s t a l l bezel.
(4) Connect battery cable.
INSTRUMENT CLUSTER ASSEMBLY (Fig. 7)
REMOVAL
(1) Disconnect b a t t e r y negative cable.
(2) Tape or cover steering column t o prevent d a m -
age t o p a i n t .
(3) Remove bezel.
(4) Remove lower steering column cover 4 screws.
(5) Spread upper steering column cover o u t o f t h e
l o c k i n g tangs and slide downward.
(6) Disconnect P R N D 2 1 actuator cable f r o m steer-
i n g column i f equipped.
INSTRUMENT
PANEL
(7) Loosen heater and A/C control. P u l l r e a r w a r d t o
clear forward m o u n t on cluster housing.
(8) Remove 6 screws t h a t r e t a i n cluster. P u l l clus-
ter r e a r w a r d and disconnect 2 large connectors.
(9) Remove cluster.
INSTALLATION
(1) Connect 2 large connectors to cluster.
(2) Position cluster to i n s t r u m e n t panel a n d i n s t a l l
6 r e t a i n i n g screws.
(3) I n s t a l l heater A/C control.
(4) Connect P R N D 2 1 actuator to steering c o l u m n i f
equipped.
(5) Position upper steering column cover a n d slide
u p w a r d u n t i l tangs snap i n t o place.
(6) Position lower steering cover a n d i n s t a l l 4
screws.
(7) I n s t a l l bezel.
(8) Remove protective cover from steering c o l u m n .
(9) Connect b a t t e r y cable.
(10) Check to see t h a t a l l instruments are function-
i n g properly.
PRINTED CIRCUIT BOARD
A visual inspection of t h e conductors should be
made for cracks or damaged circuits. I f no v i s u a l
damage is evident, each circuit should be tested for
MAP LAMP
BRACKET
HEADLAMP
SWITCH
BRACKET-MAP LAMP MOUNTING
(W/O CLOCK)
CLUSTER
ASSEMBLY
RR8EC80
Fig. 7 Instrument Panel Cluster and Switches
Advertisement
Table of Contents
