Table of Contents
Advertisement
•
CLUTCH
6 - 1 5
CLUTCH PEDAL REMOVAL/INSTALLATION
(1) Remove the retaining ring, flat washer a n d
wave washer that secure the clutch master cylinder
push rod to the clutch pedal pin (Fig. 6).
(2) Remove the fastener that secures the pedal
shaft to the pedal support.
(3) Slide the pedal shaft out of the left side of the
support and out of the clutch pedal.
(4) Slide the push rod off the clutch pedal pin and
remove the clutch pedal.
(5) Remove and inspect the bushings i n the clutch
pedal shaft bore and on the bushing on the pedal pin.
Replace any bushing that is worn or damaged.
(6) lubricate the pedal shaft, pedal shaft bore and
all the bushings with Mopar multi purpose grease, or
with a silicone grease.
(7) Insert the pedal pin into the cylinder push rod.
T h e n position* the clutch pedal i n the support.
(8) Slide the pedal shaft through the clutch pedal
bore and bushings.
(9) Install the fastener that secures the pedal shaft
to the support.
(10) Secure the push rod to the pedal pin with the
wave washer, flat washer and retaining ring (Fig. 6).
Advertisement
Table of Contents
