Table of Contents
Advertisement
•
Fig. 12 Hazard Warning Switch Knob
stalk) to t u r n signal switch pivot, t h e n p u t screw
t h r o u g h pivot and t i g h t e n securely. Be sure t h a t
d i m m e r switch rod is i n control stalk pocket.
(b) T i l t C o l u m n : Position t u r n signal switch i n
upper column housing. Place switch i n r i g h t t u r n
position.
I n s t a l l
three
m o u n t i n g
screws a n d
t i g h t e n . P u l l l i n k i n position between t u r n signal
s w i t c h and wiper-washer switch pivot, and secure
w i t h screw. U s i n g Tool C-4156, i n s t a l l upper bear-
WARNING BUZZER/CHIME MODULE
8M - 5
Fig. 13 Key-In Switch
i n g spring, cancelling cam and lock plate w i t h n e w
r e t a i n e r s p r i n g . I n s t a l l hazard w a r n i n g knob w i t h
screw.
(4) Connect w i r i n g harness connectors (Figs. 8, 9).
(5) I n s t a l l w i r i n g t r o u g h t o column w i t h four plas-
tic buttons.
(6) Position steering wheel master serration over
missing tooth on steering shaft.
(7) I n s t a l l h o r n switch a n d steering wheel nut.
T i g h t e n steering wheel n u t t o 6 1 N » m (45 f t . lbs.).
(8) Place gearshift lever i n P a r k position, connect
battery negative cable and test operation o f t u r n sig-
n a l , hazard w a r n i n g , h o r n and d i m m e r switch.
Advertisement
Table of Contents
