Table of Contents
Advertisement
19 - 58
STEERING
Fig. 9 Multi-Function Control Stalk Removal/
Installation
(8) Remove t h e t u r n signal a n d flasher switch re-
t a i n i n g screws and l i f t t h e switch u p w a r d out of t h e
way (Fig. 10).
STEERING SHAFT
STEERING COLUMN
Fig. 10 Turn Signal & Flasher Switch Removal
(9) Detach t h e h o r n a n d t h e key l a m p ground
wires.
(10) Remove t h e r e t a i n i n g screw and l i f t t h e i g n i -
t i o n k e y l a m p o u t o f t h e way (Fig. 11).
STEERING SHAFT DISASSEMBLY
(1) Remove t h e four screws t h a t attach t h e bearing
housing t o t h e lock housing (Fig. 12).
(2) Remove t h e " s n a p " r e t a i n i n g r i n g f r o m t h e up-
per end o f t h e steering shaft (Fig. 12).
CAUTION: Do not allow steering shaft to slide out
of the jacket.
(3) Remove t h e b e a r i n g housing from t h e shaft
(Fig. 13).
(4) Remove t h e lock plate spring and t h e lock plate
from t h e steering shaft (Fig. 13).
(5) Remove t h e steering column shaft from t h e
lower end o f t h e c o l u m n .
•
Fig. 11 Ignition Key Lamp
Fig. 12 Bearing Housing Screw & Upper "Snap"
Retaining Ring Removal
Fig. 13 Bearing Housing & Lock Plate Removal
LOCK HOUSING DISASSEMBLY
(1) Remove t h e i g n i t i o n key. Remove t h e screw and
l i f t out t h e i g n i t i o n k e y buzzer/chime switch from t h e
Advertisement
Table of Contents
