Table of Contents
Advertisement
•
RADIO, ANTENNA AND SPEAKERS
8F - 5
(4) W o r k i n g t h r o u g h t h e glove box opening, p u l l
antenna cable f r o m retainer clip ( F i g . 5).
Fig. 5 Removing Antenna Cable
(5) Open r i g h t door and remove cable g r o m m e t
from A p i l l a r (Fig. 6).
Fig. 6 Removing Grommet
(6) P u l l cable from A p i l l a r .
(7) Loosen antenna mast from a n t e n n a body. D o
n o t r e m o v e a t t h i s t i m e .
(8) Loosen cap n u t using tool C4816 ( F i g . 7).
(9) W h i l e h o l d i n g antenna mast w i t h one hand, re-
move cap n u t w i t h other hand.
(10) Lower antenna assembly d o w n f a r enough to
g a i n access t o antenna body (Fig. 8).
(11) W h i l e h o l d i n g body remove a n t e n n a mast.
(12) P u l l antenna body and cable assembly f r o m
fender area and remove.
(13) Remove adapter on fender.
INSTALLATION
(1) Route anteanna cable between fender a n d dash
panel to A p i l l a r area.
ADAPTER
PR517 A
Fig. 7 Cap Nut and Adapter
Fig. 8 Removing or Installing Antenna Body
(2) Insert antenna mast t h r o u g h hole i n fender and
screw into antenna body.
(3) P u l l assembly u p a n d position into place and
hold.
(4) I n s t a l l adapter m a k i n g sure t a b indexes w i t h
opening i n fender a n d
antenna body.
(5) I n s t a l l cap n u t and t i g h t e n securely w i t h tool C-
4816.
(6) Insert cable t h r o u g h opening i n A p i l l a r a n d
f r o m inside glove box opening p u l l i n far enough to
snap grommet into place.
(7) Route cable t h r o u g h r e t a i n e r clip, over to radio,
and p l u g i n t o back of radio.
(8) I n s t a l l glove box.
(9) Connect fusible l i n k .
Advertisement
Table of Contents
