Dodge D150 1990 Service Manual page 369

8E - 10 INSTRUMENT PANEL AND GAUGES
•
c o n t i n u i t y w i t h a n ohmmeter or a test l i g h t . Should
an open c i r c u i t be detected, the p r i n t e d c i r c u i t board
should be replaced.
REMOVAL (FIG. 8)
(1) Remove i n s t r u m e n t cluster. See cluster r e -
moval.
(2) Remove l a m p socket assemblies.
(3) Remove gauge m o u n t i n g screws a n d remove
gauges.
(4) Remove p r i n t e d c i r c u i t board m o u n t i n g screws.
(5) Remove p r i n t e d c i r c u i t board from cluster hous-
i n g .
INSTALLATION
CAUTION; Do not overtighten mounting screws or
damage to circuit board and/or cluster housing will
occur.
(1) Position p r i n t e d c i r c u i t board o n cluster hous-
i n g , i n s t a l l m o u n t i n g screws and t i g h t e n .
(2) I n s t a l l gauges.
(3) I n s t a l l l a m p socket assemblies. Be sure i l l u m i -
n a t i o n lamp diffusers are installed.
(4) I n s t a l l i n s t r u m e n t cluster.
MOUNTING SCREWS (7)
PRINTED CIRCUIT
BOARD
J908E-68
Fig. 8 Printed Circuit Board