Subaru Impreza 2002 Service Manual page 4238

4) Lower the vehicle.
5) Insert the reverse check cable to the gear shift
lever assembly, then fix with the band clip.
NOTE:
• Cut off the extra band clip.
• Make sure that the reverse check cable is insert-
ed into gear shift lever assembly without any clear-
ance.
6) Fix the slider and reverse check cable end with
spring pin.
NOTE:
Apply grease to the sliding part of slider.
(A)
(A) Slider
(B) Spring pin
7) Lift-up the vehicle.
REVERSE CHECK CABLE
TR0978
(B)
TR0958
CS-15
8) Install the reverse check cable end, washer and
snap pin to reverse check lever.
NOTE:
Take care to install the snap pin in proper direction.
(D)
(B)
(A) Reverse check cable
(B) Washer
(C) Snap pin
(D) Front side
9) Fix the reverse check cable to clip of stay.
NOTE:
Install the reverse check cable to upper side of
stay.
(A)
(A) Reverse check cable
(B) Clip
10) Install the rear exhaust pipe and muffler. <Ref.
to EX(TURBO)-13, INSTALLATION, Rear Exhaust
Pipe.>, <Ref. to EX(TURBO)-14, INSTALLATION,
Muffler.>
11) Install the console box. <Ref. to EI-40, INSTAL-
LATION, Console Box.>
CONTROL SYSTEMS
(C)
(A)
TR0957
(B)
TR0974