Subaru Impreza 2002 Service Manual page 4239

CONTROL SYSTEMS
C: INSPECTION
1) Verify whether the slider moves smoothly. If not,
adjust the reverse check cable or check damage of
slider. <Ref. to CS-16, ADJUSTMENT, Reverse
Check Cable.>
2) Check that the gear can be shift to reverse,
when the slider is pulled up. If the gear can not be
shift to reverse, adjust the reverse check cable.
<Ref. to CS-16, ADJUSTMENT, Reverse Check
Cable.>
3) Check that the gear can not be shift to reverse,
when the slider is not pulled up. If the gear can be
shift to reverse, adjust or replace the reverse check
cable. <Ref. to CS-16, ADJUSTMENT, Reverse
Check Cable.>
D: ADJUSTMENT
1) Set the vehicle on a lift.
2) Remove the under cover.
3) Remove the rear exhaust pipe and muffer. <Ref.
to EX(TURBO)-13, REMOVAL, Rear Exhaust
Pipe.>, <Ref. to EX(TURBO)-14, REMOVAL, Muf-
fler.>
4) Remove the crossmember. <Ref. to 6MT-35,
REMOVAL, Transmission Mounting System.>
5) Remove the snap pin and washer, and then sep-
arate the reverse check cable from reverse check
lever.
(B)
(A) Snap pin
(B) Washer
(C) Reverse check cable
REVERSE CHECK CABLE
(A)
(C)
TR0954
CS-16
6) Move the transmission to right side, and then re-
move the stay bolt and reverse check cable.
NOTE:
If the transmission is not moved, stay bolt will con-
tact body and damage may occur.
(A)
(B)
(A) Stay
(B) Stay bolt
7) Adjust the length between end of cable plate and
reverse check cable to 84 mm (3.31 in), and then
tighten the lock nut.
Tightening torque:
6 N·m (0.6 kgf-m, 4.4 ft-lb)
(A) 84 mm (3.31 in)
8) Move the transmission to right side, and then in-
stall the stay.
Tightening torque:
T: 32 N·m (3.3 kgf-m, 23.6 ft-lb)
(A)
T
(A) Stay
TR0976
(A)
TR0973
TR0977