Table of Contents
Advertisement
[NFC Security]
Set whether to show the confirmation message or enable the password input before settings are
written to the printer from an Android device with the NFC interface.
To use the NFC Security function, the settings must be written from the Android device while the
printer is powered off. The confirmation message or password input screen is shown when the printer
is powered on.
The options are as follows:
None
No confirmation message is shown and no password is required before the settings are written to
the printer.
Confirm
The confirmation message is shown before the settings are written to the printer.
Password
You need to enter the password set in the [Password] menu before the settings are written to the
printer.
[Change Password]
Change the password.
You can enter 4 to 32 characters. Alphabets (capital and small letters), numbers and symbols can be
used.
The setting items are as follows:
admin
This is the setting item for factory.
Strictly for SATO authorized personnel use.
manager
The password for accessing the [Service] menu.
Strictly for SATO authorized personnel use.
level1
The password for accessing the [Settings] menu.
•
The [admin] and [manager] passwords are for factory and maintenance personnel. You
cannot change these passwords.
[Start on AC]
Set whether to power on/off the printer by powering on/off the main power source.
Power on/off the printer by powering on/off the main power source.
290
[Start on AC]
Advertisement
Table of Contents
