Table of Contents
Advertisement
1. Check and set the items as listed on the [Paper Sensor] menu.
2. Tap
to start the test print. Tap
To stop the test print, first pause the print and then tap
The setting items are as follows:
Label Width
Shows the necessary media width of the test print.
The necessary media width is 50.8 mm (2") for [Small].
Label Length
Set the length of one piece of the media used for the test print.
The setting range is from 600 to 2400 dots.
Pitch
Set the print position in the vertical direction.
The setting range is from -45 to +45 dots.
When you decrease the setting value, the print position moves in the feed direction.
When you increase the setting value, the print position moves opposite the feed direction.
Offset
Set the tear-off position/cut position/dispense stop position.
The setting range is from -45 to +45 dots.
When you decrease the setting value, the stop position moves in the feed direction.
When you increase the setting value, the stop position moves opposite the feed direction.
Darkness Adjust
Fine tune the print darkness of the test print.
0 is the lightest and 99 is the darkest.
•
The length of 1 dot is 0.083 mm (0.0033").
•
You can change the unit to dots or inches in the [System] > [Regional] > [Unit] menu.
•
The value of [Label Length], [Pitch], [Offset] and [Darkness Adjust] set in the [Paper
Sensor] will be reflected to the same item settings in the [Factory] menu, [Configure
List] menu, [Configure QR] menu and [BD address] menu.
[BD address]
Print the BD address.
1. Check and set the items as listed on the [BD address] menu.
2. Tap
to start the test print. Tap
To stop the test print, first pause the print and then tap
to pause the print.
.
to pause the print.
.
296
[Test Print]
Advertisement
Table of Contents
