Changing the Flap Position of the Media Guide
Change the flap position of the media guide in accordance with the core diameter of the media roll. Set
it to the upper position when using the φ40 mm (φ1.5") core, or the lower position when using the φ26
mm (φ1") core.
•
When changing the flap position, do not use excessive force. Doing so may damage
the printer.
•
The flap is set to the lower position after factory shipment. When using the φ26 mm
(φ1") core, use it as it is.
1. Press the cover open button (1) to open the top cover (2).
2. Remove the media if it is already loaded.
3. Push the two tabs of the flap (3) inwards and pull them towards the front.
•
The flap can also be removed completely from the media guide.
191