Table of Contents
Advertisement
Do not save the user format data registered at printing in the printer. The user format data
remains in the printer memory until the printer is powered off. You need to register a user format
again after reboot.
[STCL]
To use STCL as a printer command, set the following items:
[Command Head]
Set the command head.
The setting items are as follows:
[Control Code]
Set the control code.
The options are as follows:
Auto
Perform the protocol detection automatically.
ESC|LF|NUL
Set the control code to ESC|LF|NUL.
7B|7C|7D
Set the control code to 7B|7C|7D.
Custom
Change the first to third byte codes.
[1st Byte Code]
Set the first byte code.
You can change the code only if you have selected [Custom] in the [Control Code] menu.
The setting range is from 0 to 255.
•
Each code must be set to different values.
[2nd Byte Code]
Set the second byte code.
You can change the code only if you have selected [Custom] in the [Control Code] menu.
The setting range is from 0 to 255.
•
Each code must be set to different values.
271
Advertisement
Table of Contents
