Table of Contents
Advertisement
•
The length of 1 dot is 0.083 mm (0.0033").
•
You can change the unit to dots or inches in the [System] > [Regional] > [Unit] menu.
Adjusting direction of the print reference position and base reference point
(1) Feed direction
(2) Liner
(3) Label
(4) Gap
(5) Adjustment of vertical base reference point
(6) Base reference point after adjustment
(7) Adjustment of horizontal base reference point
(8) Print reference position
[Advanced]
Set detailed sensor operation and print motion.
The setting items are as follows:
[Calibrate]
Adjust the media sensor level.
In instances of media detection malfunction, adjust the media sensor level.
The setting items are as follows:
[Auto-calibration]
Perform the auto-calibration for the selected media sensor.
228
[Advanced]
Advertisement
Table of Contents
