Table of Contents
Advertisement
[Feed After Error]
Set whether to automatically feed the media when recovering from an error and changing to Online
mode.
Feed the media when changing to Online mode after recovering from an error.
Do not feed the media when changing to Online mode after recovering from an error.
However, if [Feed At Power On] is enabled, the printer feeds the media when it is powered on and
changes to Online mode.
Also, if [Auto Measure] is enabled, the printer feeds the media when it changes to Online mode for
the first time after being powered on.
[Feed At Power On]
Set whether to automatically feed the media at power on.
Feed the media when the printer is powered on and changes to Online mode.
Do not feed the media when changing to Online mode after the printer is powered on.
Also, if [Auto Measure] is enabled, the printer feeds the media when it changes to Online mode for
the first time after being powered on.
[Finisher Feed]
Set the media feed amount for Tear-off, cut and dispense stop. Set the media feed amount based on
the print head position of 0.
The actual media feed amount is the value of [Offset] + [Finisher Feed].
The setting range is from 0 to 3060 dots.
•
The length of 1 dot is 0.083 mm (0.0033").
•
You can change the unit to dots or inches in the [System] > [Regional] > [Unit] menu.
[Paper End]
Select the sensor for sensing the paper end.
The options are as follows:
Using I-mark
Use the I-mark sensor (reflective type) to detect the paper end.
Using Gap
Use the Gap sensor (transmissive type) to detect the paper end.
236
[Advanced]
Advertisement
Table of Contents
