SATO FX3-LX Operator's Manual page 237

Hide thumbs Also See for FX3-LX:

Table of Contents

[Prioritize]

For printer settings, set whether to prioritize the settings through the printer or through commands.

The options are as follows:

Prioritize the settings through commands.

Prioritize the settings through the printer.

Enable or disable the reprint function.

If you enabled [Reprint], you can tap [REPRINT] on the Online screen to print the previous data again.

The previous data will be lost if you power off the printer.

[Print End Position]

Adjust the media stop position or cut position when the [Sensor Type] is set to [None]. This adjustment

also sets the blank amount from the media stop position.

The setting range is from 0 to 6000 dots.

The length of 1 dot is 0.083 mm (0.0033").

You can change the unit to dots or inches in the [System] > [Regional] > [Unit] menu.