Table of Contents
Advertisement
Replacing the Battery
Pack
Power cords and
cables
Opening and closing
the print head
•
Be sure to charge the battery pack before its first use or when it has
not been used for a long time.
•
When not using the battery pack, store it in a location with low
humidity to avoid the battery from leaking or rusting.
•
Clean the terminals of the battery pack with a dry cloth before use
since dirty terminals may cause an unstable connection, battery
exhaustion or an inability to charge.
•
Use only the specified battery pack.
•
When replacing the battery pack, make sure to install the pack in
the correct orientation. Incorrectly replacing the battery creates
the danger of injury or damage to surrounding areas, or causes
explosion.
•
Replace with a small-size rechargeable battery (Lithium ion battery).
Apply insulation treatment to the old battery pack by sealing the
contact with tape or the like and ask our sales representative or
service center for the measures to be taken to recycle the reusable
materials. Do not place the battery pack together with other batteries
such as dry batteries.
•
The life expectancy of the lithium ion battery pack varies depending
on usage. We recommend that you replace the battery after 300
charge cycles or 3 years from the date of first use, whichever comes
first.
•
If you notice any dents or cracks on your battery crust caused by
strong impacts or shocks, stop using the battery immediately and
replace it with a new one. Continued use under these conditions may
lead to abnormal overheating or fire.
•
Grab power cords and cables by their plug when removing from
electrical outlets or connector ports.
Removing power cords and cables by grabbing the cord/cable may
result in exposure of wires, breakage, fire, or electric shock.
•
Do not place power cords and cables near heaters or other sources
of heat. Placing power cords and cables near heaters or other
sources of heat may result in melting of the power cord/cable
sheathing, fire, or electric shock.
•
When opening and closing the print head, be careful not to insert
foreign materials, other than media, in the print head. Otherwise, it
may result in injury or damage.
16
Safety Precautions
Advertisement
Table of Contents
