•
Use the wire saddle for the AC adapter cable as necessary.
4. Load the media in the printer.
5. Install the printer to the mount bracket.
a. Put protrusions A on both sides of the joint plate into the guides (12) on the mount bracket.
b. Put protrusions B on both sides of the joint plate into the angle adjustment points (13) on the
mount bracket.
c. Insert the AC adapter cable (14) into the DC input connector (15) of the printer.
6. Adjust the angle of the printer.
a. Set protrusions B on both sides of the joint plate into the angle adjustment points (13) on the
mount bracket.
b. Power on the printer.
c. Move protrusions B and adjust the angle to the position for the easiest view.
95