SATO FX3-LX Operator's Manual page 326

Hide thumbs Also See for FX3-LX:

Table of Contents

Enable or disable the BCC check function.

Appears only if you have selected [STATUS5] in the [Flow Control] menu.

[Delay Reply ENQ]

Set the period to delay status reply to status request ENQ.

Available only if you have selected [STATUS3], [STATUS4 ENQ], [STATUS5], or [NONE] in the [Flow

Control] menu.

The setting range is from 0 to 9999 ms.

Normally, keep this setting at the initial value.

[Status4 Cyclic Response]

Set the interval for the cyclic status response.

Available only if you have selected [STATUS4] in the [Flow Control] menu.

The setting range is from 100 to 999 ms.

[Wi-Fi Protected Setup(WPS)]

Set the wireless LAN connection using the push button or PIN code method.

Refer to the manual of the access point device for its operation.

Not available when [Wi-Fi Direct] is active.

The setting items are as follows:

[Button (PBC)]

Set the wireless LAN connection using the push button method.

1. Tap [Button (PBC)] in the [Wi-Fi Protected Setup(WPS)] menu.

2. When [Scanning...] appears on the screen, press the WPS button on the access point of the

wireless LAN device.

3. When the connection to the access point is established, [Successfully configured.] appears on the

[Wi-Fi Setting]