List Of Initial Values; [Printing] Menu - SATO FX3-LX Operator's Manual

Hide thumbs Also See for FX3-LX:

Table of Contents

List of Initial Values

The initial value refers to the setting value of the printer when it was shipped from the factory. The

table below shows the initial value of each setting item.

Setting Item

[Label Length]

[Label Width]

[Auto Measure]

[Sensor Type]

[I-Mark Position]

[Label Size]

[I-Mark Offset]

[Print Mode]

Initial Value

4 ips (If the printer is connected to AC power)

3 ips (If only the optional battery is installed)

I-Mark (When [Print Mode] is [Dispenser],

[Tear-Off], [Continuous], [Cutter], or [Partial

None (When [Print Mode] is [Linerless tearoff]

or [Linerless cutter])

Bottom I-Mark

If [Auto-mode] is enabled

Dispenser (If no option is installed and

media is loaded for dispenser mode)

Tear-Off (If no option is installed and media

is loaded for continuous/tear-off mode)

Cutter (If cutter kit is installed)

Partial cutter (If partial cutter kit is installed)

If [Auto-mode] is disabled

Before (If [Print Mode] is set to [Tear-Off] or

[Partial cutter])

After (If [Print Mode] is set to [Dispenser],

[Cutter], [Linerless tearoff], or [Linerless

None (If [Print Mode] is set to [Continuous])