Table of Contents
Advertisement
Unmounting the Printer from the Mount Bracket
When opening the top cover to replace media, etc., unmount the printer from the mount bracket.
•
Do not connect or disconnect the power cord while your hands are wet. Doing so could
cause an electric shock.
•
When unmounting the printer from the mount kit, hold the printer with both hands.
Otherwise, you may be injured by the printer fallen.
•
Carefully handle the wall mount kit so that you may be not injured by its sharp edges.
1. Power off the printer.
•
The print data will be cleared if the printer is powered off. Please reissue the print data
again.
2. Remove the AC adapter cable from the printer.
3. Unmount the printer from the mount bracket.
a. Lift up the printer, and remove protrusions B from the groove of the angle adjustment part (
b. By using protrusions A as a pivot, pull protrusions B forward and unmount them from the mount
bracket (
c. Lift up the printer, and unmount protrusions A from the mount bracket (
).
Installing the Optional Wall Mount Kit
96
).
).
Advertisement
Table of Contents
