Poe And Ethernet Rj-45 Jack; To +48 Vdc Jack; Operating Mode Switch - ICP DAS USA tDS-718i-D User Manual

Tiny Serial-to-Ethernet Device Server

PoE and Ethernet RJ-45 Jack

The tDS-700 series module is equipped with an RJ-45 jack that is used as the 10/100 Base-TX
Ethernet port and features networking capabilities, supports PoE power supply. The DS-2200 series
module is equipped with two RJ-45 jacks that are used as the 10/100 Base-TX Ethernet port and
features networking capabilities, only ETH1 supports PoE power supply. When an Ethernet link is
detected and an Ethernet packet is received, the Link/Act LED (Orange) indicator will be
illuminated. When power is supplied via PoE (Power-over-Ethernet), the PoE LED (Green) indicator
will be illuminated.
+12 to +48 V Jack
DC
The tDS-700 series is equipped with a +12V to +48 V jack that can be used to connect a power
DC DC
supply. The DS-2200 series is equipped with a +12V to +48 V terminal that can be used to
DC DC
connect a power supply. If no PoE switch is available on site, a DC adapter can be used to power the
tDS-700/DS-2200 series module.

Operating Mode Switch

Init Mode: Configuration mode
Run Mode: Firmware operation
For tDS-700/DS-2200 series modules, the operating mode switch is set to the Run position by
default. In order to update the firmware for the tDS-700/DS-2200 series module, the switch must
be moved from the Run position to the Init position. The switch must be returned to the Run
position after the update is complete.
Copyright © 2020 ICP DAS CO., Ltd. All Rights Reserved. -16 -