Application > LP+ SETUP
This item selects the characters per inch (CPI) value.
Selections
Factory Default
This is the number of lines to be printed per inch. For example, at 6 LPI there
is 1/6 inch from the top of one print line to the top of the next print line.
Selections
Factory Default
This item allows you to select certain host commands to be ignored by the
printer.
Enable
Ignore All
Ignore CPI
Ignore LPI
Factory Default
Application > LP+ Setup > Select CPI
10.0, 12.0, 13.3, 15.0, 17.1, and 20.0 CPI
10.0 CPI
Application > LP+ Setup > Select LPI
6.0, 8.0, 10.3 LPI
6.0 LPI
Application > LP+ Setup > Host Command
All host commands accepted by printer.
All commands are ignored.
All CPI commands are ignored.
All LPI commands are ignored.
Enable
150