Printronix Auto ID T800 Series Administrator's Manual page 32

5. Place the paper, printing side face up, through the media sensor and place the label leading edge onto
the platen roller. Move the blue media guides to fit the label width.
6. Press down on both sides of the top cover to close it gently.
7. Initiate Auto Calibrate via the Home Screen ICON
ENTER key will activate the Auto-Calibrate function. Calibration may also be activated via the Sensors
menus within the Settings
Note: Calibration must be performed whenever new media or ribbon is installed or any configuration
parameter that affects the sensors is modified.
Your printer is equipped with media sensors that detect the top-of-form position on media with label length
indicators (gaps, notches, holes, or black marks). These sensors also detect when a Paper Out condition
exists.
, selecting this shortcut ICON and pressing the
section (Sensors > Calibrate > Auto Calibrate).
32