Printronix Auto ID T800 Series Administrator's Manual page 229

Displayed Message
OPTION NOT INSTALLED
Table 13. LCD Message Troubleshooting
If the printer is powered on with the cutter enabled in Media >
Handling > Media Handling, but the cutter itself is open (in the
down position, or the cutter upper enclosure is removed) the printer
cannot detect the cutter. When using the cutter, the printer must be
powered on with the cutter in the up position and the cutter upper
enclosure installed.
1. Check that the cutter option is installed, connected in the up
position, and the upper enclosure installed before powering
on the printer.
2. Install the cutter option or change to the correct option in the
Media > Handling > Media Handling menu.
3. If the error persists, contact your authorized customer service
representative.
... OR ...
If the printer is powered on in Peel-Off in Media > Handling > Media
Handling, but the Peel option cannot be detected by the printer.
When using Peel-Off handling, the printer must be powered on with
the Peel option installed.
1. Check that the Peel option is installed and connected before
powering on the printer.
2. Install the Peel option or change to the correct option in the
Media > Handling > Media Handling menu.
If the error persists, contact your authorized customer service
representative.
Solution/Explanation
229