Printronix Auto ID T800 Series Administrator's Manual page 42

Table of Contents

Advertisement

5. Select the "Diagnostics" submenu and press
6. Find "Manual Calibrate" and then press
7. Follow the instructions displayed on the LCD and press the
8. During the last step of Manual Calibrate, the printer will advance the media and attempt to detect the
label length indicators and stop at the Top-of-Form position. The Sensed Distance value will then
display for one second. The calibrate is successful when the Sensed Distance value correctly matches
that of the installed media. If "CALIBRATION FAIL" error displays, run Manual Calibrate again.
NOTE:
The amount of media sampled during Manual Calibrate is based on the length of a label and
the transitions detected without error, between a label and its label length indicators.
9. Press the PAUSE key to place the printer OFFLINE (Home Screen).
10. Press the FEED key several times. Each time you press FEED, the media advances one label length
and stops.
NOTE:
After a form feed, the position of the leading edge of the next label depends on the type of
Media Handling mode selected via Media > Handling > Media Handling. Tear-Off Strip Media
Handling positions the label edge at the tear bar, while Continuous positions the label edge
under the printhead.
11. Once the correct values are confirmed, save them to the desired configuration menu before powering
off the printer.
ENTER.
ENTER to start the process.
ENTER key to move to the next step.
42

Hide quick links:

Advertisement

Table of Contents
loading

Related Products for Printronix Auto ID T800 Series

This manual is also suitable for:

T830T820

Table of Contents