Network > Wlan - Printronix Auto ID T800 Series Administrator's Manual

This menu appears only if a 10/100Base-T Network Interface Card (NIC) is
installed. The Ethernet Speed menu has five different speed modes to allow
compatibility with different systems and networks.
Auto Select
10 Half Duplex
10 Full Duplex
100 Half Duplex
100 Full Duplex
Factory Default
Network > WLAN
WARNING
Most of these menu items will not change until configuration of the printer is
deemed complete by the user and the printer is placed ONLINE. Upon going
online, the printer will automatically reboot and set these options.
This item allows you to set the IP Address for the TCP/IP protocol using a
virtual keyboard. Make sure you enter the complete IP address, including the
period symbol between the segments.
Structure
Factory Default
IMPORTANT
IMPORTANT
Network > Ethernet > Ethernet Speed
Tells the 10/100Base-T NIC to perform an auto
detection scheme and configure itself to be 10 Half
Duplex, 10 Full Duplex, 100 Half Duplex, or 100 Full
Duplex.
Tells the 10/100Base-T NIC to communicate at 10
Megabits per second using half duplex.
Tells the 10/100Base-T NIC to communicate at 10
Megabits per second using full duplex.
Tells the 10/100Base-T NIC to communicate at 100
Megabits per second using half duplex.
Tells the 10/100Base-T NIC to communicate at 100
Megabits per second using full duplex.
Auto Select
Network > WLAN> IP Address
Seg1.Seg2.Seg3.Seg4
000.000.000.000
Disable BootP, ARP or DHCP before trying to
change the IP address.
If changed, the printer reboots when it is placed
ONLINE.
119