Printronix Auto ID T800 Series Administrator's Manual page 258

Table 28. Thermal PTX_SETUP Commands
Command Sub-Command
MEDIA_HANDLING
MIRROR
MODE
ODV
OVERSTRIKE
WIDTH
RFID OVERSTRIKE_REPORT
STATISTICS_REPORT
STATISTICS_CLEAR
PRINTJOB START
END
Parameter
Sets the type of media handling:
Value
0 - Continuous
1 - Tear-Off Strip
2 - Tear-Off (Not Available)
3 - Peel-Off
4 - Cut
Value of 0 turns mirroring off,
Value
non-zero turns mirroring on.
Sets the print mode to Thermal
X
Transfer.
Sets the print mode to Direct
D
Thermal.
Enables the ODV unit so that ODV
1
begins verifying printed barcodes.
Requests the printer to back up one
0
form (as defined by the Form
Length) and then print out an
overstrike pattern.
This command should only be used
if the Validator > Control > Validator
Action is set to Retry Form.
Sets the page width in 1/1000"
Value
units.
Enables/disables reporting of RFID
ON/OFF
overstrikes to the host. The default
is OFF (disabled).
Enables/disables reporting of RFID
ON/OFF
statistics to the host. The default is
OFF (disabled).
Clears the RFID statistics.
Start of job marker. Results in a
jobID
"start of job" message sent back to
host through the PPM port when a
job starts printing.
End of job marker. Results in a "end
jobID
of job" message sent back to host
through the PPM port when the job
finishes printing.
Description
258