Printronix Auto ID T800 Series Administrator's Manual page 109

Host IO > Serial Port > Poll Character
This option is for the Series1 protocol. Whenever the printer receives this
character, it sends a response to the host indicating the current state of the
printer.
Minimum 00 hex
Maximum FF hex
Factory Default 00 hex
Host IO > Serial Port > Poll Response
This option is for the Series1 protocol. After receiving a poll character, the
printer will wait the poll response time in milliseconds before sending the
response.
Minimum 0 ms
Maximum 30 ms
Factory Default 0 ms
Host IO > Serial Port > Idle Response
This option is for the Series1 protocol and is relevant when the buffer is less
than 75% full.
The printer does not send a response character when
Disable
the buffer is less than 75% full..
The printer sends a response character every two
Enable
seconds while the buffer is less than 75% full.
Factory Default Disable
109