Host Io > Serial Port - Printronix Auto ID T800 Series Administrator's Manual

Host IO > Serial Port
Sets the flow control mode for host IO data transfer.
Software Only
Software &
Hardware
Factory Default
IMPORTANT
This option configures the amount of memory allocated for the Serial
buffer incremented in 1 Kbyte increments.
Options
Factory Default
Host IO > Serial > Flow Control
In the Software Only mode the data flow control does
not use any of the Hardware line (RTS/CTS).
The Serial Debug IO will be active when set to
Software Only.
Side Effects: Menu Request to Send and selection
RTS/CTS from menu Data Protocol are hidden. If
RTS/CTS was the current setting, then it is changed to
XON/XOFF.
In the Software & Hardware mode, the data flow
control also uses the hardware lines (RTS/CTS).
The Serial Debug IO will not be active when set to
Software & Hardware.
Side Effects: Menu Request to Send and selection
RTS/CTS from menu Data Protocol are unhidden.
Software Only
Serial Debug is only needed by Field Engineers
and is not required for normal operation.
Host IO > Serial Port > Buffer (Kbytes)
1, 16, 32, or 64
16 Kbytes
104