Printronix Auto ID T800 Series Administrator's Manual page 152

Application > LP+ Setup > Italic Print
To determine if the text printed by the LP+ uses italics.
Disable Text is printed normally.
Forward Slant Text is printed with a forward slant.
Backward Slant Text is printed with a backward slant.
Factory Default Disable
Application > LP+ Setup > Slashed Zero
This parameter allows you to print the numeral '0' with or without the slash.
Disable Zero is printed without a slash.
Enable Zero is printed with a slash.
Factory Default Disable
IMPORTANT
This option does not apply to OCR-A or OCR-B.
Application > LP+ Setup > Text Position
Specifies where the text will be positioned in the line space.
Top of Line Text is positioned at the top of the line space.
Text is positioned as if it were at the bottom of a line
Bottom of Line space at 6 LPI. The following example picture below
shows both Top of Line and Bottom of Line positions.
Factory Default Bottom of Line
IMPORTANT
This option does not apply to OCR-A or OCR-B.
152