Printronix Auto ID T800 Series Administrator's Manual page 135

Application > Control > PGL Diagnostics
This menu sets the error reporting capability of PGL when selected as the
current Active IGP emulation.
Full error checking reported. Any element that falls off
On
the current page is reported as an error.
Puts the printer in debug mode whenever a form is
defined in CREATE mode. Each line of the CREATE
Debug Mode
form will be printed along with an error if one has
occurred.
Allows you to halt the printer if a PGL error occurs. If
you select this option, the PGL error prints on the
paper, the message "PGL Error" displays on the front
Fault
panel and the printer goes OFFLINE. You must clear
the error before the printer can resume normal
operation.
Full error checking reported. Error messages are sent
Host back to the host through the port based on the menu
"Ret. Status Port" instead of being printed on paper.
There is no error checking. Graphic elements such as
Off alpha, line, barcodes, etc., will be clipped if they are
beyond the page boundaries.
Factory Default On
This is only shown when PGL is the Active IGP
IMPORTANT
Emulation.
135