Printronix Auto ID T800 Series Administrator's Manual page 98

System > Printer Mgmt > Ret. Status Port
This option selects the port for return Status Commands used by the
emulations. For PGL, this is the ~STATUS command, and for ZGL, this is
the ^HS command.
Sends the data through the same port used to
Automatic
receive the application job.
Disable Status is not sent back to the host.
Ethernet data port.
E-NET Data Port
Serial Serial RS-232 port
Ethernet port as set in Status Port Number menu
E-NET Stat Port
USB USB
Factory Default Automatic
System > Printer Mgmt > Status Port Number
This menu selects the port number where the printer sends the emulation
status.
Minimum 1025
Maximum 65535
Factory Default 3002
System > Printer Mgmt > PNE Port Choice
This menu selects which port the printer expects PNE (PrintNet Enterprise) to
connect to, via Ethernet or USB. The factory default is Ethernet.
Disable PNE communication will be disabled.
Ethernet Use Ethernet to connect with PNE.
USB Use USB to connect with PNE.
Factory Default Ethernet
98