Loading External Media - Printronix Auto ID T800 Series Administrator's Manual

Loading External Media

If using either an external media holder or folded labels, feed the media through the rear external label
entrance chute.
1. Open the printer top cover by pulling the blue levers, located on each side, toward the front of the
printer, then lift the top cover.
2. Separate and hold open the media holders.
3. Set the media holder lock switch to down to keep the media holders separated.
4. Feed the paper from rear external label entrance chute, printing side face up, through the media
sensor and place the label leading edge onto the platen roller. Move the media guides to fit the label
width.
5. Press down on both sides of the top cover to close it gently.
6. Initiate Auto Calibrate via the Home Screen ICON
ENTER key will activate the Auto-Calibrate function or initiate calibration via the Sensors
, selecting this shortcut ICON and pressing the
menus
33