Printronix Auto ID T800 Series Administrator's Manual page 162

Application > P-Series XQ Setup > Vertical DPI
This feature enables the thermal printer to print images as close as possible
to the same size as those originally programmed for a line matrix or laser
printer by selecting a vertical resolution that matches that of the printer that
the file was originally generated for.
Although the range allows a selection of up to 400 dpi, the T800 is capable of
printing up to 203 dpi or 300 dpi vertical resolution, depending on the print
head installed.
Minimum 72
Maximum 400
Factory Default 72
Application > P-Series XQ Setup > Define CR code
This option controls the action of the printer when it receives a Carriage
Return code (0D hex) from the host computer. If this feature is enabled, each
time the printer receives a carriage return, it inserts an additional Line Feed
code (0A hex) into the data stream. Do not use this feature if the host
computer sends line feeds to the printer.
Does not insert an extra line feed after each carriage
CR = CR
return.
Inserts an extra line feed after each carriage return.
CR = CR + LF The next print position will be print position 1 of the
next line.
Factory Default CR = CR
Application > P-Series XQ Setup > Auto LF
This option defines the printer action when print data is received past the
forms width setting.
Disable Discards any data past the forms width.
Performs an automatic carriage return and line feed
Enable
when data is received past the forms width.
Factory Default Disable
162