Printronix Auto ID T800 Series Administrator's Manual page 153

Application > LP+ Setup > Form Length (xx)
Specifies form length in three different units for all preferences of the user:
inches, millimeters, and even lines.
Minimum 0.1 inches
Maximum 99.0 inches
Factory Default 1.9 inches
Application > LP+ Setup > Form Width (xx)
Specifies form width in three different units for all preferences of the user:
inches, millimeters, and even characters.
Minimum 0.1 inches
Maximum 4.1 inches
Factory Default 4.1 inches
The width should not exceed the actual paper
WARNING
width to prevent damage to the platen.
Application > LP+ Setup > Left Margin
Set in characters. Character zero is defined as the far left edge of the page,
and column numbering increments from left to right.
Minimum 0 characters
Maximum 369 characters
Factory Default 0 characters
Application > LP+ Setup > Right Margin
Set in characters. Character zero is defined as the far right edge of the page,
and column numbering increments from right to left.
Minimum 0 characters
Maximum 369 characters
Factory Default 0 characters
153