Printronix Auto ID T800 Series Administrator's Manual page 257

Table 28. Thermal PTX_SETUP Commands
Command Sub-Command
ENGINE ALM_WIDE
ALM_NARROW
ALM_ENABLE
EJECT
IMAGE_SHFT_H
ENGINE IMAGE_SHFT_V
LENGTH
Parameter
Set the Auto Label Mapping wide
wide width
width (in units of 1/1000"; e.g., a
wide width value of 1000 = 1"),
which represents the width of the
image in the file sent from the host
which is to be auto label mapped
into several labels, each of which
will have a width of narrow width.
# of labels=wide width/narrow width
(rounded down)
Set the Auto Label Mapping narrow
narrow width
width, which represents the width of
one auto mapped label (in units of
1/1000"; e.g., a narrow width value
of 1000 = 1"). This width should be
set prior to the wide width. In
addition, it can never exceed the
physical width of the printer. If it
does, the narrow width will be
automatically reduced to the Page
Width value set in the configuration
menu.
Set Auto Label Mapping to Narrow,
N/W/*
Wide, or Off. Enter N for Narrow, W
for Wide, or any other letter to
disable ALM. By default, only the
Narrow option is implemented.
Performs a page eject.
Shifts the image Value horizontally
Value
in 1/1000" units. If Value is out of the
specified range (-1" to +1"), the
command will be ignored.
Shifts the image Value vertically in
Value
1/1000" units. If Value is out of the
specified range (-1" to +6"), the
command will be ignored.
Sets the page length in 1/1000"
Value
units.
Description
257