Printronix Auto ID T800 Series Administrator's Manual page 226

Displayed Message
ERROR: PROGRAM NOT
VALID
ERROR OCCURRED
FLUSHING QUEUES
FATAL ERROR
xxxx
FILE EXISTS
Enable Overwrite
FILE SYS FULL
Delete Files
FILE SYS FULL
Optimize&Reboot
FILE SYS INVALID
Optimize&Reboot
Table 13. LCD Message Troubleshooting
The printer does not see a program in flash memory.
1. Power off the printer for 15 seconds, then power back on.
2. If the problem persists, contact your authorized customer
service representative.
An interim message displays while the printer discards host data
it cannot use because a fault condition exists. While this
message displays, the asterisk (*) rotates.
Wait. When the asterisk (*) stops rotating, a different fault
message will appear; troubleshoot the final message. Contact
your authorized customer service representative
A fatal software error has occurred.
1. Cycle Power. Run the print job again. If the message appears,
load the latest firmware.
2. Run the print job again. If the message appears, record the
display message and follow the instructions for Diagnostics for
Fatal Error.
3. Contact your authorized customer service representative.
The printer operator tried to save a file using the name of an
existing stored file.
1. Enter the System > Flash File Edit menu and enable the
Overwrite Files feature to overwrite the existing file.
Insufficient flash memory available to store file. Given there is
128MB of Flash Memory, this error is still possible but unlikely.
1. Go to the System > Flash File Edit section of the menu.
2. Check the amount of flash memory that can be optimized from
the "Flash Reclaimable" menu.
3. If this value is small, then use "Delete Files" to delete
unwanted files.
4. If this value is large, then run "Optimize & Reboot".
File system not detected or flash was corrupted.
1. Run the System > Flash File Edit > Optimize & Reboot
feature.
The file system was given an invalid request.
1. Run the System > Flash File Edit > Optimize & Reboot
feature.
Solution/Explanation
226