Sony MG40 Series Command Reference Manual page 97

Master
Th is function is used to set and execute master calibration.
Th is function can be used when the master calibration function is on.
 MCM command
Set master calibration value
The command sets the master calibration value.
Command format
Return format
Target
Save setting values
Examples of use
Compatible command
Acquire master calibration value
The command acquires the master calibration value.
Command format
Return format
Target
Examples of use
Compatible command
Relocate master calibraiton value
The command relocates the master calibration value.
 Aft er the command has been transmitted, the wait to go past reference point status is established so initiate
the go past reference point operation. Aft er the reference point has been passed, the master calibration value is
relocated.
Command format
Return format
Target
Examples of use
Compatible command
MG40 Series
MCV Designated axis =<Value>
<Value> Corresponds to output resolution (Factory setting: Zero)
Execution results
Designated axis
Setting values saved.
MCV[01B]=123.2315
Transmission :
(Set the master calibration value of axis B for the MG42 hub unit
ID01 to 123.2315.)
Return : OK000 (Successfully completed.)
Designated axis MS=<Value>
MCV Designated axis ?
MCV Designated axis =<Value>
<Value> Corresponds to output resolution
Designated axis
MCV[00A]?
Transmission :
(Acquire the master calibration value of axis A for the MG41 main unit.)
Return : MCV[00A]=100.0000 (Th e master calibration value is 100.0000.)
None
MCR Designated axis
Execution results
Designated axis
MCR[01B]
Transmission :
(Relocate the master calibration value of axis B for the MG42 hub unit ID01.)
Return : OK000 (Successfully completed.)
Designated axis MR
Measurement
Ethernet
mode
Measurement
Ethernet
mode
Measurement
Ethernet
mode
CC-Link
CC-Link
CC-Link
4-9
(E)