Sony MG40 Series Command Reference Manual page 94

Preset
Th is function is used to set numerical values in the measurement values.
Note
• In the wait to go past reference point status, a mode error results, and values can neither be set nor
called.
• Values can neither be set nor called for an axis in the error status.
Set
The command sets the numerical values in the current values.
Command format
Return format
Target
Save setting values
Examples of use
Compatible command
Acquire
The command acquires the preset values.
Command format
Return format
Target
Examples of use
Compatible command
Call
The command calls the preset values.
Command format
Return format
Target
Examples of use
Compatibility command
4-6
(E)
PSS Designated axis =<Value>
<Value> Corresponds to output resolution (Factory setting: Zero)
Execution results
Designated axis, MG42 hub unit, all axes
Setting values saved.
PSS[01B]=123.2315
Transmission :
(Set axis B for the MG42 hub unit ID01 to 123.2315.)
Return : OK000 (Successfully completed.)
Designated axis P=<Value>
PSS Designated axis ?
PSS Designated axis =<Value>
<Value> Corresponds to output resolution
Designated axis
PSS[00A]?
Transmission :
(Acquire the preset value of axis A for the MG41 main unit.)
Return : PSS[00A]=100.0000 (Th e preset value is 100.0000.)
None
PSR Designated axis
Execution results
Designated axis, MG42 hub unit, all axes

PSR[ ]
Transmission : (Call the preset values for all the axes.)
Return : OK000 (Successfully completed.)
Designated axis RCL
Measurement
Ethernet
mode
Measurement
Ethernet
mode
Measurement
Ethernet
mode
CC-Link
CC-Link
CC-Link
MG40 Series