Sony MG40 Series Command Reference Manual page 123

IP address
Th is function is used to set and acquire the Ethernet source station IP address.
Th e IP address setting is refl ected the next time the equipment is started up.
When an IP address is acquired aft er its setting has been changed, the IP address set before the change is
refl ected will be acquired.
Set
The command sets the Ethernet source station IP address.
Command format
Return format
Target
Save setting values
Examples of use
Compatible command
Acquire
The command acquires the Ethernet source station IP address.
Command format
Return format
Target
Examples of use
Compatible command
MG40 Series
Setup
mode
NIP=<IP address>
<IP address> 1.0.0.1 to 223.255.255.254 (excluding 127.x.x.x)
(Factory setting: 192.168.1.100)
Execution results
MG41 main unit
Setting values saved. (Th e setting values are saved at the same time as the setting
command is executed.)
NIP=192.168.1.10
Transmission :
Return : OK000
None
Setup
mode
NIP?
NIP=<IP address>
<IP address> 1.0.0.1 to 233.255.255.254
MG41 main unit
NIP?
Transmission :
Return : NIP=192.168.1.10
None
Ethernet
Measurement
Ethernet
mode
4-35
(E)