Sony MG40 Series Command Reference Manual page 105

Data transmission control
Th is function is used to set start or stop for the data transmission and acquire the current transmission
status.
Set
The command sets start or stop for the data transmission.
Command format
Return format
Target
Save setting values
Examples of use
Compatible command
Acquire
The command acquires the current data transmission status.
Command format
Return format
Target
Examples of use
Compatible command
MG40 Series
NDT=<Value> <Standby time>
<Value> 0 : Stop transmission (Factory setting)
1 : Start transmission
<Standby time> (ms) 10 to 1000 (factory setting: 10 ms)
Standby time: Length of interval time between data transmissions
When the specifi ed value is omitted: 10 ms
Execution results
MG41 main unit
Setting values not saved.
NDT=1 100
Transmission :
Return : OK000
NDT=0 100
Transmission :
Return : OK000
None
Setup
mode
NDT?
NDT=<Value> <Standby time>
<Value> 0 : Transmission stopped
1 : Transmission underway
<Standby time> (ms) 10 to 1000
MG41 main unit
NDT?
Transmission :
Return : NDT=0 100
None
Measurement
Ethernet
mode
Measurement
Ethernet
mode
4-17
(E)